| 1. | The longer the time of heat preservation is , the finer the second phase is
二次加热处理的合金中第二相发生了显著的变化。 |
| 2. | Standard test method for quenching time of heat - treating fluids magnetic quenchometer method
热处理液体淬火时间的标准试验方法 |
| 3. | Test method for quenching time of heat - treating fluids - magnetic quenchometer method
热处理液体淬火时间的试验方法.磁性冷却速度试验器法 |
| 4. | In the preparation technology of making porous bioceramics with controllable macrostructure , the time of heat preservation was one of the important influence factors
摘要保温时间是可控多孔生物陶瓷制备技术的重要影响因之一。 |
| 5. | 5 . the measuring end of protective tube is of ultra thin design , which greatly reduces time of heat conductionand increase sensitivity of thermocouple
5超簿的测量端保护套管设计，极大的减少热传递时间，大大的提高了热电偶的灵敏度。 |
| 6. | The results indicated that the time of heat preservation had important influence upon the macrostructure , apparent porosity rate , volume weight , the pervasion rate , shrinkage rate and the compressive strength
研究结果表明，保温时间对孔结构、气孔率与容重、水渗透率、收缩率以及强度有着重要的影响。 |
| 7. | The research shows that using temperatures and times of heat application similar to those used in commercial pasteurization of liquid egg products are sufficient in deactivating the h5n1 strain of virus . here
这项研究说明，对食物进行热处理的时间和温度如果与商业上用来处理蛋汁的巴氏灭菌类似，就足以灭活流感病毒 |
| 8. | Thirdly best maintenance system is determined eventually : the constant temperature is 205 c , the constant pressure is 2 mpa , time of heating up is 3 h ; the time of constant temperature is 9 h and time of cooling down is 3 h
并最终确定了最佳养护制度：恒温温度为205 ，恒温压力2mpa ；升温时间为3h ；恒温时间为9h ：降温时间为3h 。 |
| 9. | And non - fourier heat conduction is encountered . when the wavelength of the heat carrier is comparable to the characteristic length of the structures , or the time of heat conduction is shorter than that required for reaching the state of thermal equilibrium , the heat conduction has wave characteristics
当载热体的微时间尺度与能量激发特征时间相比拟时,或者传热发生的时间比达到热力学平衡态所需的时间短时,热传导就可能出现波动性质。 |
| 10. | When the time of heat preservation prolonged , the intensity of most orientation of perovskite phase became stronger , and the full width at half maximum ( fwhm ) decreased . when the time of heat preservation was 80 seconds , the intensity of ( 100 ) and ( 110 ) orientation began to decrease
循环次数从1次增加到3次, plt薄膜的( 100 )和( 200 )峰的衍射强度逐渐增强,薄膜的结晶性提高,铁电性能逐渐增强,循环4次溅射后,薄膜的结晶性和铁电性开始下降。 |
